3 Axles Tank Trailer-manufacture,factory,supplier from China

Fence semi trailer is a relatively common means of cargo transportation, with a wide range of types and uses.According to the regulations, the height of the fence truck trailer shall not exceed 4.2 meters. According to the regulations, the loading height of heavy and medium-sized trucks and semi-trailers shall not exceed 4 meters from the ground, and the vehicle carrying containers shall not exceed 4.2 meters. Semi trailers are mostly 3 axles trailers, which are connected with semi-trailers through front traction pins.

1. Early wear of the central part of the tire.The main reason is that the tire inflation volume is too large, which not only affects the shock absorption performance of the tire, but also causes excessive deformation of the tire.2. Both sides of the tire are worn too much.The main reason: insufficient inflation of the tire or long-term overload driving, so that the contact surface between the tire and the ground is large, causing the two sides of the tire to contact the ground and form early wear.3.

When there is an electrical fault in the oil tank trailer, it is an important prerequisite for maintenance to quickly and accurately judge the fault. After a lot of practice and research for a long time, the maintenance engineers have realized that the following methods are very practical in electrical diagnosis.Observation methodIf the starter of the ofuel tanker trailer cannot be started, turn on the headlight first, observe its brightness, and judge whether the fault is caused by poor contact of the power line or battery power loss.

Changing the hydraulic oil looks like a simple job, but many friends of the driver of the rear-turning semi-trailer do not know how to change it correctly. They often mix the new and old hydraulic oil, which will greatly reduce the service life of the hydraulic system. So how to change the hydraulic oil of the rear tipper semi-trailer? Are there any precautions?The traditional method of replacing hydraulic oil for rear dump semi-trailer is nothing more than extracting the hydraulic oil from the hydraulic oil tank, replacing the hydraulic oil filter element, and then adding new hydraulic oil.

To measure a trailer axle, first, you need to identify the type of trailer axle. There are two types of trailer axles, including the straight axle and drop axle. The straight axle is mounted directly below the trailer deck, while the drop axle is mounted a few inches below the trailer deck.Here are the steps to measure a trailer axle:Measure the length of the axle from one end to the other. You can use a tape measure for this.Determine the weight capacity of the axle.

1. Pipeline laying and installationA. Arrange the pipeline reasonably according to the vehicle model. The long pipe shall be connected with the air storage tank of the rear relay valve. The length shall be appropriate and shall not be too loose or tight. The pipe clamp shall be locked on the thread clamp screw on the right side of the longitudinal dye. The thread clamp shall not be missed.

The cost of a trailer can vary widely depending on several factors, including the type of trailer, its size, specifications, brand, and market conditions.

We should also pay attention to some problems when using the skeleton semi trailer, although its operation is simple, although the skeleton trailer is large, but the operation is not so complicated, what needs our attention is the correct driving. First, the skeleton truck trailer fully considers the use of the operator's feelings, because the workers are usually very hard, and the environment is not good, which requires the skeleton trailer to provide the user with comfort as much as possible, assist direction, comfortable seats, open vision, simple and practical buttons, many things

In recent years, due to the interest trend, the semi-trailer market is mixed, and it is difficult to argue between true and false.

Here are the basic steps to adjust brakes on a semi trailer:First, park the trailer on a level surface and chock the wheels to prevent movement.Remove the dust cap from the brake drum.Use a brake adjusting tool to reach inside the drum and turn the adjusting star wheel in a clockwise direction to tighten the brake shoes against the drum.Tighten the shoes until you feel resistance from the brake drum.Then, turn the star wheel back 10-15 times counterclockwise to provide proper clearance between the brake shoes and the drum.Put the dust cap back on the brake drum to protect it from debris and mo